Garage Door Spring Repair & Replacement – How to Do it Yourself

If you want to fix your garage door yourself, here are a few tips. First, always wear safety goggles and gloves, and use a step ladder or stool. If possible, replace the springs one at a time. If one fails, consider hiring a professional to save you both time and money. Garage door spring repair and replacement are easier said than done, but it is possible. Keep reading to learn how to properly do the job.

Before you begin repairing or replacing your garage door springs, you should make sure that the door is balanced. Doing this before a spring fails could prevent major consequences. Additionally, you should lubricate the springs to prevent further damage. You can do this yourself by purchasing spring lubricant for as little as $5. The installation of a safety cable will cost you around $140 to $200. Finally, you should always check the installation instructions before attempting to repair the springs yourself.

To replace the spring, you must first remove the garage door opener. Then, you can remove the winding bar. The first spring is located at the bottom of the garage door. Unwind it by pulling it toward the center of the door with one hand. Next, insert another bar into the hole above the first one. Once the second one is inserted, you can use it to anchor the first one. The second bar can then be inserted into the hole above the first one and continue to nudge the cone.

Before attempting to repair the springs yourself, you should make sure you know the type of spring system that your door uses. Precision technicians have the necessary equipment to handle both torsion and extension spring systems. Torsion springs are located above the door opening while extension springs are located alongside the opening. You can contact Precision garage door repair for more information. And remember that if your door springs have already broken, make sure to have them checked by a professional.

To replace the torsion spring, you need to unscrew the center cone and remove its bolts. Next, you need to remove the single bushing that attaches the torsion spring to the center cone. Once you remove the spring, slide the new one into place by pushing it into the center bearing. To repair the other spring, you must replace the bottom brackets and the cable drums. Once this is done, you should replace the bearings as well.

A few simple tips for Garage Door Spring Repair & Replacement are listed below. Regardless of which spring type you have, you need to lubricate them once every year. A silicone-based lubricant will not harm the spring coils. However, a professional will have the tools necessary to tune up the springs. After all, a garage door is a moving mechanical device, so lubricate it regularly. This is essential to prevent rust and corrosion.

Leave a Reply

Your email address will not be published. Required fields are marked *